Installation of tower column for beam calibrator:

Insert the ring sleeve from the upper end of the tower column. The theoretical sinking head of the ring sleeve should be downward, and then lock it. Place the top rod and top cap of the oil cylinder into the column tube one by one. Installation of tower column beams and bars; Push the end of the chain without a hook upwards three times from under the pulley, then pass it through the top cap of the tower column and lock it with the locking mechanism on the top cap.

Installation of foot operated pneumatic oil pump for beam calibrator:

1. Remove the pneumatic pump and its components from the packaging

2. Place the manufacturer's sealed bag on the thread of the tracheal joint, remove the plastic pipe from the rear end joint of the pneumatic oil pump, and select the tracheal joint.